Thingiverse
Perpetual Trophy
by jeremy505
1
Downloads
3
Likes
0
Makes
The original trophy is great, but I was looking for a base that could have nameplates and additional levels added over time.
The square base and the hexagonal base have registration holes/pins built into the model to assist in assembly.
Image to Keychain (https://makerworld.com/en/makerlab/imageToKeychain?from=makerlab) was used to make the nameplates. The exported nameplates were always 100mm wide, but with a little bit of scaling in my slicer I was able to get it to fit nicely.
Everything was printed at 150% scale and used the Twist 270 trophy but it should in theory work with any of the ones from the original upload. Shout out to the original creator flowalistik!
The square base and the hexagonal base have registration holes/pins built into the model to assist in assembly.
Image to Keychain (https://makerworld.com/en/makerlab/imageToKeychain?from=makerlab) was used to make the nameplates. The exported nameplates were always 100mm wide, but with a little bit of scaling in my slicer I was able to get it to fit nicely.
Everything was printed at 150% scale and used the Twist 270 trophy but it should in theory work with any of the ones from the original upload. Shout out to the original creator flowalistik!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
