Thingiverse
Electronics
Voir le modèle
Personal Peltier Cooler
109
Téléchargements
116
Likes
0
Makes
This personal cooling unit will make your summers a little less hot.
Attach it to your wrist for optimal blood flow.
Best used in my opinion between 5v to 8v.
You could use up to 12v but be carefull it doesn't get too cold (or too hot on the other side of the Peltier module).
I used 100% infill.
No rafts or support needed.
3d printed parts used:
-cooler with band.stl
-cooler lid.stl
-band extender.stl (optional)
electronic parts:
-40mm Peltier module(12v)
-10x40x40mm heatsink
-10x40x40mm fan(12v)
-thermal paste between heatsink and Peltier module (optional)
assembly:
1.slide the peltier module (cold side down) in the bottom of the cooler, there is a raised lip where the module should fit in precisely. If it doesn't, use some glue.
2.Insert the heatsink from the top into the cooler, put some thermal paste in between them if you have some.
3.insert the fan from the top into the cooler, make sure that the wires are facing upwards.
4.Clamp on the cooler li
Attach it to your wrist for optimal blood flow.
Best used in my opinion between 5v to 8v.
You could use up to 12v but be carefull it doesn't get too cold (or too hot on the other side of the Peltier module).
I used 100% infill.
No rafts or support needed.
3d printed parts used:
-cooler with band.stl
-cooler lid.stl
-band extender.stl (optional)
electronic parts:
-40mm Peltier module(12v)
-10x40x40mm heatsink
-10x40x40mm fan(12v)
-thermal paste between heatsink and Peltier module (optional)
assembly:
1.slide the peltier module (cold side down) in the bottom of the cooler, there is a raised lip where the module should fit in precisely. If it doesn't, use some glue.
2.Insert the heatsink from the top into the cooler, put some thermal paste in between them if you have some.
3.insert the fan from the top into the cooler, make sure that the wires are facing upwards.
4.Clamp on the cooler li
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
