Thingiverse
PET Bottle Cutter
por JohnnyTZZO
1
Descargas
0
Likes
0
Makes
I used the original design from user "Prouting".
I modified some dimensions and shapes, altered the piece to accommodate a 1/2" steel tube to hold the bottle, and added a hole for a screw to secure the blade.
The original design is quite tight on the blade, disregarding the need for the screw hole, but I only discovered this after printing. Congratulations on the original design!
Use a 0.2mm resolution and 15% infill, NO NEED SUPORTS; print with the orientation shown in the TinkerCad image for better printing efficiency. At 0.2mm, it should take around 3 hours to print both parts.
The original design already includes blade fitting for 4, 6, 8, and 10mm heights of the fillet to be cut.
I modified some dimensions and shapes, altered the piece to accommodate a 1/2" steel tube to hold the bottle, and added a hole for a screw to secure the blade.
The original design is quite tight on the blade, disregarding the need for the screw hole, but I only discovered this after printing. Congratulations on the original design!
Use a 0.2mm resolution and 15% infill, NO NEED SUPORTS; print with the orientation shown in the TinkerCad image for better printing efficiency. At 0.2mm, it should take around 3 hours to print both parts.
The original design already includes blade fitting for 4, 6, 8, and 10mm heights of the fillet to be cut.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!