Pet Leash Hook

Needed somewhere to hang our dog's leash so I drew up this quick design. The paw print is a raised emboss. There are 2 versions...one without holes to hang with 3M command strips and one with holes for a #8 screw. There is also a file for caps to cover the # 8 screw. The elliptical hook printed fine without any supports.

if you print the screw caps, it works best if printed with a 0.4mm nozzle with 0.2mm layer height and the model is oriented on the print bed with the opening facing up. Note not all #8 screws are exactly the same. if the cap is too tight to push on with your finger, just heat the open side up for a few seconds with a lighter and it will slide right on and will snug up on the screw as it cools.

Enjoy!