PETG Support Interface Calibration (PLA Base)

by PrintinBad · Test Models

86 Downloads

27 Likes

39 Makes

IT:In questo test, solo i layer verdi vanno stampati in PETG.Si tratta della trama di interfaccia dei supporti, utile per calibrare:Distanza Z superioreSpaziatura interfaccia superioreIl numero di layer di interfaccia in PETG (consigliati 1–3)Tutto il resto va stampato in PLA. EN:In this test, only the green layers are printed in PETG.They represent the support interface pattern, used to calibrate:Upper Z distanceTop interface spacingThe number of PETG interface layers (recommended: 1–3)All the rest should be printed in PLA.

support interface petg interface petg support dual filament multimaterial print multi-material test petg pla combo petg test support distance z interface gap support calibration bridge support test petg bridging calibration cube support structures support material interface tuning perfect supports support gap test z distance test

Similar Models

6 Suggestions

PETG Support Interface Calibration (PLA Base)

Similar Models

Add to Collection