PETG Supports for PLA

These are my settings for Anycubic Kobra 3, to utilize PETG for supports while printing PLA parts. I have not tested the inverse, but I would imagine similar results would occur. This file contains no actual model, only settings I have found that work for me. This generates supports that are extremely easy to remove, while providing a super clean supported surface on the part. Use at own discretion. Nozzle clogs are possible if the PETG is not cleared properly, or at the proper temperature. Contamination can occur if the two materials are not cleared out of the nozzle completely, with the risk of reduced part strength. I have not had any issues so far.