Thingiverse
PETG Temperature Tower
von jbritt1234
80
Downloads
45
Likes
0
Makes
This is a remix of quirix's temperature tower but I removed the cones and tailored it specifically towards my Ender 3.
The gcode file attached is set to change temps, using what I feel I can print PETG at comfortably without getting too hot for the stock bowden tube. It's sliced using what I have so far for my PETG profile. It's not perfect, but works well enough for this test.
I didn't really see the point in the cones, they are designed to go above the height on each layer where you would adjust the temp. So, I dropped those.
The gcode file attached is set to change temps, using what I feel I can print PETG at comfortably without getting too hot for the stock bowden tube. It's sliced using what I have so far for my PETG profile. It's not perfect, but works well enough for this test.
I didn't really see the point in the cones, they are designed to go above the height on each layer where you would adjust the temp. So, I dropped those.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!