Petsfang CR-Touch Mount

This mount allows for you to use a CR-Touch with your Petsfang system.
The main changes are:
> Removed a section off from the ABL mount for the cable
> Made it easier to fit the ABL and install it to the rest of the printer
> Added 4mm of spacing to the screw holes to lower the ABL slightly
> Very slightly made the screw holes larger for easier fitting

This model should work with most resolutions, materials, and infill above 10%.
I'd recommend printing with a brim since it doesn't add to much filament and time and reduces the chances of a print fail.
The uploaded model should be in the correct printing orientation.

My printer currently doesn't have any working nozzles, so I have yet to test this and also aren't entirely sure of what offsets to set. Once i print and test this, I'll upload the information here ASAP!
Estimated time from slicer is ~30mins at 0.20mm, 15% infill, 60m/s.

Offsets (Ender 3, stock): {x, y, z}
Offsets (Ender 3, E3D V6): {x, y, z}