Thingiverse
Phantom 3 Pro simple gimbal lock
door Byroman
49
Downloads
31
Likes
1
Makes
This is a simple, no frills, Phantom 3 Pro gimbal lock. I love the design of some of the other locks you see posted here, however there was an issue with most of them rubbing on the foam inside of the hardshell backpack case. This design doesn't rub at all!
The ring around the camera should slide right on. If its a little too snug, a very small amount of sanding may be required to get the right fit (I stress - a SMALL amount).
Not sure if this design will fit the P3A since I do not know if the camera ring size is the same.
Enjoy!
The ring around the camera should slide right on. If its a little too snug, a very small amount of sanding may be required to get the right fit (I stress - a SMALL amount).
Not sure if this design will fit the P3A since I do not know if the camera ring size is the same.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
