Thingiverse
Phase 10 - CardBox - Kartenbox
von MrNiceDM
76
Downloads
34
Likes
2
Makes
the Box consist of two parts - Cover an Card tray
both parts are pushed into each other until they click into place
Open: both white surfaces are pressed together and the halves are pulled apart
ForCard dimensions: 91 mm x 59 mm and the stacking height is 34 mm
max possible stacking height is 40 mm
The direction of printing is, the letters are upside down.
The largest area of the box halves lie on the print bed.
Other Boxes:
SKIPBO BOX -> https://www.thingiverse.com/thing:5136115
UNO Card Box without UNO writing -> https://www.thingiverse.com/thing:5141721
UNO Junior Card Box -> https://www.thingiverse.com/thing:5146159
both parts are pushed into each other until they click into place
Open: both white surfaces are pressed together and the halves are pulled apart
ForCard dimensions: 91 mm x 59 mm and the stacking height is 34 mm
max possible stacking height is 40 mm
The direction of printing is, the letters are upside down.
The largest area of the box halves lie on the print bed.
Other Boxes:
SKIPBO BOX -> https://www.thingiverse.com/thing:5136115
UNO Card Box without UNO writing -> https://www.thingiverse.com/thing:5141721
UNO Junior Card Box -> https://www.thingiverse.com/thing:5146159
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
