Philips (Hue Motion) Sensor - holder

Designed a quite simple holder for the Philips Hue Motion Sensor that sits over the door.With a 20 degrees angle, so there is bigger chance of the sensor too recognize someone at the door.The magnetic part screws into place using a normal M3 screw through threaded hole.And the lip(lower part of the model) gets squeezed between the wall and door seal.Therefor I uploaded 3 versions with different thickness of the lip(1, 1.5 & 2 mm lip).Also the height of the "lip"/the part that gets between the door seal is 11 mm.(more sizes on request)I used the 1 mm and that was good enough.Print instructionsNo needs of support of any sort.Infill is suggested. I printed mine with 20%.More perimeters(walls) might be good for rigidity.Bracket/holder for a corner, can be printed as imported.