Philips Hue Motion Sensor - holder

Designed a quite simple holder for the Philips Hue Motion Sensor that sits over the door.
With a 20 degrees angle, so there is bigger chance of the sensor too recognize someone at the door.

The magnetic part screws into place using a normal M3 screw through threaded hole.
And the lip gets squeezed between the wall and door seal.
Therefor I uploaded 3 versions (1, 1.5 & 2 mm lip - of thickness).
Also the length of the "lip"/the part that gets between the door seal is 11 mm.
(more sizes on request)

I used the 1 mm and that was good enough.

No needs of support of any sort.
Infill is suggested. I printed mine with 20%.
Bracket/holder for a corner, can be printed as imported.