Slicer Discord
Philips Hue Sensor Bracket for wall inserts – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Philips Hue Sensor Bracket for wall inserts

46 Downloads
18 Likes
18 Makes
Zum Modell
Philips Hue Dimmer Modules - Corner and Wall insertsWant to discreetly mount your Philips Hue sensor in a wall, drywall, plasterboard or wood panel? No problem. My handy little adapter will fit the sensor snuggly and hide the edges of your cut-out or the new version which is also suited for corner mounting. Featuring:A hole at the rear to mount a 8x3mm magnet (Although it's not required as the sensor fits snug).A smaller hole at the rear of the brack to push the sensor out with a thin tool.Perfect flush, snug fit of the sensor in the holder.Four Options:Build Plate 1 - Wall/Drywall housing insert, to insert your hue sensor flush to a wall. The cutout should be about 62x62mm and 28mm deep.Build Plate 2 - Wall cutout cover only.Build Plate 3 - Corner module with flat topBuild Plate 4 - Corner module with a angled top (can be mounted upside down to have the angle at the bottom. Sample is printed on the Bambu X1C using white PLA on a smooth PEI board for a perfect finish. Should do wel
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Wood PLA
Mindest-Druckbett
62 mm (Klein)
Nachbearbeitung
Schleifen, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen