Philips OneBlade charging stand

This is a base I designed for my OneBlade QP2724/10, but it also should fit other OneBlade models with the same shape. It can be used both with and without the charging cable. The stand is designed so that the charging cable does not fully plug into the shaver, allowing for easy placement and removal of the device.
I printed the base in PLA without supports and with 6% gyroid infill and filled it with sand through a drilled hole in the bottom.

Disclaimer:
This design is provided as-is, without any warranty of any kind. Use, modification, and printing of this model are done at your own risk. The designer assumes no responsibility or liability for any damage to property or personal injury resulting from the use of this design.

Note:
This model is not affiliated with Philips.