Phoenix Mask

3d printed molds are used with a two-part, food-grade, platinum silicone.

Use the mask molds like a waffle iron - mix, de-gas, and pour silicone into the peripheral_mold (the one that looks like as valley), then squish the medial_mold part into the peripheral_mold/pot'o'silicone. Then let your silicone set and remove your mask.

The filter_molds are a little trickier (because of the narrow hexagonal slots). Try the "high pour" method - pouring your silicone into the filter_mold from a high point so that a narrow stream of silicone is entering at the height of the mold. Additionally, refrain (as much as possible) from trying to hit all the nooks and crannys in the filter_molds with your silicone, instead let the silicone spread out from where it lands. "High-pour" and the "spread" method will decrease the number of gaps and bubbles present in the finished silicone part.


*************************************************************************************


File naming sc