Phone Camera Stand

Here is my phone camera stand.

The stand is made so it enables rotation in two direction. Only non printable parts are 16mm M3 screw with nut and rubber band.

I used PLA.
The Part 1 (the base) was printed at 70mm/s 15% infill 0.2 resolution and 3 perimeters (0.4). I used support but i'm sure it can be done with out it as well. It came out very rigid.
About other parts.
Other parts were printed at 30% infill. Smaller parts were printed at slower speeds to get better results.
Part 3 has two versions one si for bigger phones one is for smaller. For most newer phones print the bigger version.
You need part 4 two times.
I included .ipt fills (inventor files) if somebody wants to fiddle with it.


The