Slicer Discord
Phone Charge Orientation Stand – Modello 3D stampabile da MakerWorld MakerWorld
Gadgets

Phone Charge Orientation Stand

8 Download
2 Likes
2 Makes
Vai al Modello
SummaryDon't like your phone charger that doesn't help locate your phone to the right area. Well you're in luck. My wife didn't either so i solved the issue. I picked up the Ubio Labs wireless charging pad at costco, but my wife wouldn't pay much attention to the phones location on the charger, therefore often would not get the charge she was expecting. this holder will not only hold your phone upright, but places the charger in the right location. The charging pad fits very nice and has a pass through for the power cord and a USB type plug to go under. No cable fighting . simple slip the power cord from the back, plug it in, then press the charger into the stand.UPDATED: now phone can lay on its side and charge. it is also quicker to remove your phone from the stand as the upper half is in the open.Print SettingsNotes: Print as if you have the stand on a table holding a phone. Supports were for the under hangs for the phone shelf and the wire pass through.
Categoria
Gadgets
Fonte
MakerWorld
Pubblicato
Aggiornato
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA, ABS
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione