Slicer Discord
Phone Charge Orientation Stand – 3D-printbaar model van Thingiverse Thingiverse

Phone Charge Orientation Stand

door Maffa1027
0 Downloads
1 Likes
0 Makes
Model downloaden
Don't like your phone charger that doesn't help locate your phone to the right area. Well you're in luck. My wife didn't either so i solved the issue. I picked up the Ubio Labs wireless charging pad at costco, but my wife wouldn't pay much attention to the phones location on the charger, therefore often would not get the charge she was expecting. this holder will not only hold your phone upright, but places the charger in the right location. The charging pad fits very nice and has a pass through for the power cord and a USB type plug to go under. No cable fighting . simple slip the power cord from the back, plug it in, then press the charger into the stand.

UPDATED: now phone can lay on its side and charge. it is also quicker to remove your phone from the stand as the upper half is in the open.

Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie