Back
Phone charging dock – 3D printable model from MakerWorld MakerWorld
Gadgets

Phone charging dock

by Justis
249 Downloads
46 Likes
97 Makes
Download Model
Phone charging dock. It was made to fit Type C cable. Little bit of hot glue will be needed for securing cable in place. Type C connector fits pretty snug so no glue needed there.I recommend to use sticky pads under the phone charging dock. That way you will be able to take phone from the dock just using one hand and if needed sticky pad can just peel off and reuse it again in different location.
Category
Gadgets
Source
MakerWorld
Published
15.11.2023
Updated
01.03.2026
Comments
0

Comments

No comments yet – be the first!
More Gadgets Models All MakerWorld Models More by Justis

Similar Models

6 Suggestions

Add to Collection