Phone Cradle

This is a simple phone cradle. I designed it specifically for the HTC One M9 Plus, although it should work for any phone of similar size. Note: I made this a bit wider to accommodate my phone's case as well, if you do not have a case, it may be a bit looser fitting.

Can be printed without support standing up, or laying on its side. If printing standing up, some supports for the build plate may be preferable for the small fillets at the bottom, but are not required.

Edit: After printing I realized that this thing might be a bit over engineered in terms of strength. To help remedy this I have removed the back support and replaced it with a small 45 degree support in back. I do not think this will compromise the integrity at all under normal use and it cut the print time down by ~33%.