Slicer Discord
Phone Dock with Charging – 3D-Druckmodell von MakerWorld MakerWorld
Organizers

Phone Dock with Charging

6 Downloads
3 Likes
1 Makes
Zum Modell
A clean and practical phone dock with chargin, designed for everyday desk use. The dock supports charging up to two phones at the same time for a tidy setup. 3 Versions included; Plate 1 - English text “Phone Dock with Charging” Plate 2 - Swedish text “Telefondagis med Laddning” Plate 3 - Blank (add your own text or design) What's included Phone dock (the main body) Bottom cover (the cover plate underneath for the electronics) Installation Insert the USB-c female connectors into the 3 slots. It should be press fit, use some glue if its too loose. Use solder with heatshrink or wago connectors to connect all the black- (negative) and all the red- (positive). Screw on the cover to protect the electronics. BOM 3 x USB-C female connectors (https://www.amazon.se/dp/B0C6D2YS1V?ref=ppx_yo2ov_dt_b_fed_asin_title) 1 x M2,5 / M3 self tapping screws with a maximum length of 10mm. (optional) 2 x short(15cm) usb-c to usb-c charging cables If you have ideas for improvements or variation, feel free to
Kategorie
Organizers
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen