Phone Holder

Hello it's my first idea i hope you use it with fun :D

Some settings:

Position: Recommended position is same like original STL file
Support: I use a experimantal support "Tree" in Ultimaker Cura 4.6
Diameter of screw is : Head: 7mm / Screw thread: 3.5mm
Points for springs: 7.5 Diameter

Sizes:
Maximum lenght is 200mm
Minimum high is 65mm

Manual:
Insert springs on "2.STL"
2.STL screw to table
Join 1.STL to 2.STL by springs
Ready to use

HAVE FUN :D

Warning:
This is under the HUAWEI P40 LITE E, look at your buttons (volume, lock), pressure can cause buttons to be pressed continuously.
While this problem occurs, you need to print a small part to stick to "2.STL" in order to make minimal space from the buttons.

If you have some problem wirte to me i will help you :D

Sorry about my english.