Thingiverse
Phone Mount for Nightstand
door sention
4
Downloads
4
Likes
0
Makes
I made this to be screwed onto the side of my nightstand (I have a very tall nightstand), leaving my phone at eye level. There is a gap to allow for the charger to be plugged in on the bottom. The way the charger is plugged in will preserve both the cable and the socket in the phone that it plugs into since there are no harsh angles fighting against gravity. It is angled back so that the phone won't fall forward, and it fits my massive device (Pixel 3XL with bulky otterbox case), so smaller phones should be just fine.
I print it on its side to allow for the cleanest print with least amount of cleanup. And I believe I did 30% infill and it's pretty strong.
I print it on its side to allow for the cleanest print with least amount of cleanup. And I believe I did 30% infill and it's pretty strong.
sention publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!