phone scope adapter

I elected to glue the base directly to an inexpensive phone case with a nut already installed.

I remade the thumb screws with a bit of knurling which leaves the adapter smaller to pack and access when I want to place on my binos or spotting scope.

Uses:
*one M4 nut in the base
*one M4 x 13mm Philips screws. One gets placed in the hollowed thumb screw with a bit of glue and a cap to cover it.
*One more M4 x13mm that has a small section (4 mm) of threading filed off and then pressed into the clamp and then threaded into the other type of thumb nut.

I included 2 extra of each thumb screw just in case.

Be sure to have your slicer software include supports as this design does not have them built in.

I may update this file after using it a bit.