Slicer Discord
手机支架垫脚Phone stand footrest – 3D-Druckmodell von MakerOnline MakerOnline
手机支架垫脚Phone stand footrest – Bild 1 手机支架垫脚Phone stand footrest – Bild 2
Tools

手机支架垫脚Phone stand footrest

von zwlfxxt112 · Tools
0 Downloads
2 Likes
0 Makes
Zum Modell
当你买了一个手机支架,发现手机放在它上面老是往下,根本不能保证安全驾驶的前提下用余光看地图,且原来的四个角都不能固定手机。虽说手机支架价格不高,可以重新买一个更合适的,但面对这么可爱的一个手机支架,为什么不通过创意来弥补它的不足呢。OK,说动就动,既然四个角不能固定那就换上能固定的四个角,既然老是往下,那就给手机支架再加一个支架,如此它就变成一台既可爱又可以正常使用的车内手机支架了。 When you buy a phone holder and find that the phone keeps sliding down when placed on it, making it impossible to safely drive while glancing at the map, and the original four corners cannot secure the phone, you may think that since the phone holder is not expensive, you can just buy a more suitable one. But facing such a cute phone holder, why not compensate for its shortcomings through creativity? OK, let's act on it. Since the four corners cannot be fixed, let's replace them with four fixed corners. Since the phone keeps sliding up, let's add another bracket to the phone holder. In this way, it becomes a cute and functional in-car phone holder.
Kategorie
Tools
Quelle
MakerOnline
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen