Phone Stand - Horizontal Viewing

I was tired of trying to hold my phone to watch videos at my desk while eating lunch, or trying to prop it up against something only to have it slide and fall, so I designed this stand. It's designed to hold a mobile phone of total thickness less than 12.5 mm in a horizontal viewing position, and adjusts in 5 tilt positions with angles from approximately 18 to 38 degrees from vertical. It will also hold an iPad or other tablet.

The only hardware required to assemble is:
- Screw, Socket Head Cap, M3 (2x - screw length of minimum 8 and maximum 12mm)

When assembling, particularly with PLA, the cradles snap sharply into the base. Any elephant foot or slumping on the outer edges of the cradle pivots will make it difficult to snap them into the base, so be prepared to deburr or file the edges if that's the case.

To assemble (the easiest method I've come up with):
1. Screw the support rod with the male thread to the right cradle with an M3 screw.
2. Slide the tilt support over the