Slicer Discord
Phone stand – 3D-Druckmodell von MakerWorld MakerWorld
Gadgets

Phone stand

von edittttt · Gadgets
20 Downloads
1 Likes
19 Makes
Zum Modell
HiI needed a small phone stand that would not take up much space and at the same time hold the smartphone stably.The lower resistor is at a slightly negative angle (80 degrees), so there is no risk of the phone slipping.The width of the stand is 50 mm. If you need a different width, you can scale the Z axis in the slicer.Tested vertically and horizontally on iPhone 15 and Samsung Note 10+ (78x160x9 mm) and everything OK.When placed vertically, the stand does not cover the Android function "buttons".
Kategorie
Gadgets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

edittttt veröffentlicht auch auf

3 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen