Thingiverse
Phone Stand
105
Downloads
103
Likes
2
Makes
Hey guys.
As my first creation, I designed this phone stand as I find it a mix between guided design (I must respect the phone dimensions) and freedom of design.
The one in the photos is the first version. Since then I made a revision on the design to be more stable and to allow bigger clearance for the charging cable in the bottom.
The first model is suitable for phones up to 5.5" screen (maybe bigger if it has thin bezels like S8 and S8+). I believe the v2 will be able to handle slightly bigger phones, but not that bigger.
Print took about 3h in the first version, but I couldn't get proper bed adhesion so it has warped a bit reducing stability.
Looking forward to reading your feedback.
"
took inspiration from MakerBot's Headphone Stand
https://www.thingiverse.com/thing:2050885
and
GoAftens Phone Stand
https://www.thingiverse.com/thing:2120591
"
As my first creation, I designed this phone stand as I find it a mix between guided design (I must respect the phone dimensions) and freedom of design.
The one in the photos is the first version. Since then I made a revision on the design to be more stable and to allow bigger clearance for the charging cable in the bottom.
The first model is suitable for phones up to 5.5" screen (maybe bigger if it has thin bezels like S8 and S8+). I believe the v2 will be able to handle slightly bigger phones, but not that bigger.
Print took about 3h in the first version, but I couldn't get proper bed adhesion so it has warped a bit reducing stability.
Looking forward to reading your feedback.
"
took inspiration from MakerBot's Headphone Stand
https://www.thingiverse.com/thing:2050885
and
GoAftens Phone Stand
https://www.thingiverse.com/thing:2120591
"
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
