Thingiverse
Phone Stand
von jkeatley
0
Downloads
0
Likes
0
Makes
This is a phone stand. You can lay out the base and tray together. Lay out the base on its angled back (the largest flat surface) and the tray vertical. This will require minimal supports. It requires the following additional parts:
* M4 40mm bolt
* M4 nut to fit the bolt
* M4 washer
* M4 40mm bolt
* M4 nut to fit the bolt
* M4 washer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
