Thingiverse
Phone stand
von WAVERTHEAPE
2
Downloads
49
Likes
0
Makes
Simple phone stand that works most devices!
I recommend you print this on its side, and with a lower resolution (layer height) to save time as the simplistic design doesn't benefit from a super high resolution. Mine was printed with 20% infill (cubic), could go higher for more density.
I recommend adding some rubber feet to it, to help it on flat surface, but still works great without.
Tested with a Pixel 7, Samsung S25, S20, A15, iPhone 13, 14, 16, iPad Air, and even a Nintendo Switch
I recommend you print this on its side, and with a lower resolution (layer height) to save time as the simplistic design doesn't benefit from a super high resolution. Mine was printed with 20% infill (cubic), could go higher for more density.
I recommend adding some rubber feet to it, to help it on flat surface, but still works great without.
Tested with a Pixel 7, Samsung S25, S20, A15, iPhone 13, 14, 16, iPad Air, and even a Nintendo Switch
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!