Phone Stand (two size)

I wanted something stylish and simple for my desk, but existing designs were either too small or complex prints, so I designed this!Rounded design reduces printer jerk, resulting in a clean print.Two sizes (13.5mm and 11.5mm) enables it to fit most phones (with cases!)Clearly marked sizes on the print, but clean look once device is insertedOptimised geometry for strength and balance while reducing material usageDeeper cutouts ensuring even heavier devices are held well (and can be used when docked without falling over!)I've also uploaded the version without the marked sizes, if you wanted a truly clean look!Print Settings0.2mm layer height (I used "0.2mm speed")Infill 15%Material PLA, but others should workNo support, no brimPrint on it's side, as shown in .3mf file.DesignDesigned using SolidWorks. Original .SLDPRT model and .STEP model uploaded for easy remixes!