MakerWorld
Gadgets
Model downloaden
Phone/ Tablet Stand (Bolt Action)
30
Downloads
13
Likes
5
Makes
This print comes in 4 parts grouped into two models. The base and the mechanism.To assemble:slot the bolt through the slider as it appears in the pictures.connect the pin on the bolt action to the hinge joint on the stand. (if it doesn't go in properly try sanding it a bit.)place the hinge of the stand into the large hole that fits it.snap together the two halves around the mechanism.to set in the phone stand position first lift from the back and then either lift until the mechanism stops or use the bolt action.to fold flat into it's compact travel form use the bolt action until the stand surface is flush with the top of the base. (if it doesn't quite fold flush with the bolt action just snap it shut by pressing the top)If you like it or enjoy using it please like or comment if that is possible. This is my first model and I hope to produce more for this community!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
