Thingiverse
Phone/ tablet stand
por NoycePrints
1.3k
Descargas
1.1k
Likes
18
Makes
The design challenge - Submission under Electronics
Created this small, adjustable folding stand to prop up phones and tablets. Should be a universal fit. Prints in 4 pieces and takes around 2 hours at 0.24 LH and 40% infill. Very light and compact so would be convenient for travel and day to day commutes. So far the design seems more than strong enough for it's intended purpose. I used M3 countersunk washers in order to assemble the stand in the photos however these are not essential.
Note:
Requires 6 M3x10mm countersunk screws in order to assemble. Button head screws should also work fine, just won't provide a flush fit.
UPDATE: As per request, I've since added a shorter brace file to allow the stand to have a more reclined stance.
Created this small, adjustable folding stand to prop up phones and tablets. Should be a universal fit. Prints in 4 pieces and takes around 2 hours at 0.24 LH and 40% infill. Very light and compact so would be convenient for travel and day to day commutes. So far the design seems more than strong enough for it's intended purpose. I used M3 countersunk washers in order to assemble the stand in the photos however these are not essential.
Note:
Requires 6 M3x10mm countersunk screws in order to assemble. Button head screws should also work fine, just won't provide a flush fit.
UPDATE: As per request, I've since added a shorter brace file to allow the stand to have a more reclined stance.
NoycePrints también publica en
38 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
