Phone Tent Holder (iPhone/Android)

Phone holder with hook for backpacking/tent camping. Insert phone, hang from the loop at the top of your tent. Use your phone as your tent light, and perhaps watch a movie while relaxing in nature.

Tested with iPhone 12 Pro and iPhone 11 Max

Print using the sliding arm as supports to the main part. (if imported into your slicer, you should only have to move the arm for clearance on one axis)

PLA or ABS (or any other material) should work. The arm will separate with some gentle force once printed.

Use M3 screws (and a washer) to assemble. Tighten to just tight for some noticeable friction.

Use a hair tie around ears and end of articulating arm to make it "spring loaded"

There are two mounting holes for the hook. On the back for a slightly 45deg view angle, or the top of the articulating arm for a perpendicular configuration.

After designing and testing, watch the buttons on your device. May have to adjust as needed to prevent button push.

Two M3-.50 (6mm) sc