Thingiverse
Phone Trigger R1 L1
di DaWag
2
Download
2
Likes
0
Makes
These triggers are R1 and L1 alternatives for phones.
What you will need:
Printed model
Aprox. 5cm wire (1mm diameter max)
Aluminium foil
Three pieces of foamy double tape
1mm rod (18mm long)
How make it:
1. Print model
2. Stick aluminium foil on one side of the double tape and under two pieces of them insert wire without isolation, but before second push wire through hole on one side (if you want L1 or R1)
3. This two pieces bend after 8mm and cut
4. Then stick them into their slots
5. Third piece stick on the arm in the slot
6. Take rod and push it in both printed pieces (it could be little hard)
What you will need:
Printed model
Aprox. 5cm wire (1mm diameter max)
Aluminium foil
Three pieces of foamy double tape
1mm rod (18mm long)
How make it:
1. Print model
2. Stick aluminium foil on one side of the double tape and under two pieces of them insert wire without isolation, but before second push wire through hole on one side (if you want L1 or R1)
3. This two pieces bend after 8mm and cut
4. Then stick them into their slots
5. Third piece stick on the arm in the slot
6. Take rod and push it in both printed pieces (it could be little hard)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!