MakerWorld
Other Hobby & DIY
Zum Modell
Phone tripod adjustable and foldable
102
Downloads
60
Likes
48
Makes
Tripod for phones to take stable photos all printable except for the screws that assemble the feet to the central body that I preferred to put in iron/steel to avoid them breaking easilyIt can be set both in height and as a viewing angle by widening or tightening the feet in order to tilt the entire structure, below I put the instructions on how to mount it:Fix the feet to the central body as in the photo with 5*25/30 or 4*25/30 screws with the relative nuts, the washers are optional but I preferred to put them so as not to ruin the plastic:Insert the screw with the rounded head into the hole next to the body where the feet are to be attached:Insert the central stem with the hollow facing the screw with the rounded headScrew the base of the phone holder into the top of the stemInsert the top part of the phone holder into its base
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
