Thingiverse
Phonestand
von KohlerY
0
Downloads
0
Likes
0
Makes
Super lightweight phonestand easily print it laying down, pick up, fold on the 4 creases, connect the puzzle conection and youre good to go.
At 100% it uses about 11g of filament and prints in about one hour with .12mm layerhight.
If you print this, please check with your layerhight, that you get enough connecting layers. I got 3 layers at 0.12mm each and it seems to work quite well.
At 100% it uses about 11g of filament and prints in about one hour with .12mm layerhight.
If you print this, please check with your layerhight, that you get enough connecting layers. I got 3 layers at 0.12mm each and it seems to work quite well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
