Thingiverse
Photo Holder
door linus01
3
Downloads
7
Likes
0
Makes
Photo frame made of gray PLA.
It has two holes on the back to be hung on the wall.
Photos can be inserted interlocking without using glue.
To change photos, just use the back of a pen or pencil inserted inside the holes on the back, and making a little pressure, the photo will slide out.
I recommend not to use supports and brim.
The outer box measures: 109x84x20 mm
Internal photo measures: 103x78x3 mm
Holes diameter: 10 mm
It has two holes on the back to be hung on the wall.
Photos can be inserted interlocking without using glue.
To change photos, just use the back of a pen or pencil inserted inside the holes on the back, and making a little pressure, the photo will slide out.
I recommend not to use supports and brim.
The outer box measures: 109x84x20 mm
Internal photo measures: 103x78x3 mm
Holes diameter: 10 mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
