Phrozen Transform Mono Upgrade Bezel Split

Printing:
Phrozen Transform Mono upgrade screen bezel split into two parts (left and right) with a hollow tube running the full length of the two parts. Insert and glue some 2mm piano wire or carbon fibre rod for strength and rigidity

Printed settings
Supports "touch platform" Only - otherwise the the hollow tubes will be difficult to insert the piano wire post printing
0.18 layer height
3 perimeter walls
3 top solid layers and 3 bottom solid layers
35% infill (I used 3D Infill, but hex should be ok)

Highly recommend printing on a raft to ensure a nice level bottom surface.

Insert piano wire without gluing first. Test fit all the components and check the mounting positions on the printer. Lightly sand any surface not mating correctly. Once all set, then glue the rods in place using superglue.