PI 3 Case Standoffs

I made these standoffs to mount the PI and its case to the back of my monitor. They're made to fit the cases floating around that have the standard VESA mounts. They press fit in the holes, sort of, depending on the accuracy of your printer, and are meant to have double-sided 3M sticky tape applied to the foot end for attaching to the monitor. An alternative to a press fit is to make the pin slightly undersized so the case will just slide on/off easily and use small o-rings on them to keep the case from slipping off. I printed them out of ABS with a solid infill, 2 mm layer height.