Pi Cam v2 Case

After ruining a Pi cam trying to squeeze it into a downloaded case I put together my own variant.

The PCB is secured on pins through the mounting holes on the board and held captive as the rear panel is pushed into place on the same pins. Cable can be attached before inserting the PCB to the case, or after provided the retention bar is in the released state before the back cover is in place.

Back cover has held fine for me with no adhesive but any sort of glue could be used in the back cover sockets.

Two versions of the front half of the case - "Plain" with no mounting provisions, or "Tabbed" with a tab on the right hand side (facing the camera). I've got the tabbed version in place on my Ender 3 via a binder clip while I explore where best suits my needs.