Thingiverse
Pi Camera Mount
door Toddman
97
Downloads
56
Likes
0
Makes
This is a Raspberry Pi camera mount that I designed to be installed inside a 3D printer enclosure. All parts snap together. The mount attaches with double sided mounting tape. I designed this thing with 3 configurations to suit multiple uses.
I printed this in ABS. I had good results printing part “picam A” upright with supports as shown in the screen shot.
Some light filing may be needed on the inboard of part "picam C" in order to get it to snap over part "picam B".
**Rev 2 on parts picam B and picam D adds mount holes to accept a small screw for mounting rather than using mounting tape.
I printed this in ABS. I had good results printing part “picam A” upright with supports as shown in the screen shot.
Some light filing may be needed on the inboard of part "picam C" in order to get it to snap over part "picam B".
**Rev 2 on parts picam B and picam D adds mount holes to accept a small screw for mounting rather than using mounting tape.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
