Thingiverse
Pi Camera Mount
door bitwi
0
Downloads
1
Likes
0
Makes
I needed this, so I made it.
Fits a 1&1/8 inch diameter dowel. Uses M2 screws/nuts.
----
Notes:
The back of my mount piece looks bad, because I forgot to floor it.
Also, there was a camera component very close to the mount holes.
I didn't need to use bolts in my print because the holes were very tight (too tight).
I've fixed these things in the uploaded STL.
Fits a 1&1/8 inch diameter dowel. Uses M2 screws/nuts.
----
Notes:
The back of my mount piece looks bad, because I forgot to floor it.
Also, there was a camera component very close to the mount holes.
I didn't need to use bolts in my print because the holes were very tight (too tight).
I've fixed these things in the uploaded STL.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
