Thingiverse
pi juice zero case
door haggis_supper
3
Downloads
3
Likes
0
Makes
This is my simple box and lid to hold a Raspberry Pi and pijuice zero.
No screws required apart from the ones holding the spacers to the pijuice zero.
You dont need the screws holding the pi zero to the juice, there are standoffs in the box that slide into them.
I have holes so you can see the LED's and switch, hoping to get some transparent filament and create a couple of lightpipe that slide into them and hopefully a small switch to allow you to push the pijuice switch.
No screws required apart from the ones holding the spacers to the pijuice zero.
You dont need the screws holding the pi zero to the juice, there are standoffs in the box that slide into them.
I have holes so you can see the LED's and switch, hoping to get some transparent filament and create a couple of lightpipe that slide into them and hopefully a small switch to allow you to push the pijuice switch.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
