Pi KVM - zero 2 case

I recently came across the project http://pikvm.org, something i have been thinking about designing for ages, but this is a lot better than i could have come up with.

As i am lucky enough to have a couple of Pi Zero 2's doing nothing I decided to dedicate one to this project. The only thing i found annoying was there cases available for it. THe one they point to on the website is good, but with most things uses a completely different component than i had ( HDMI to CSI module )


I have used
- Pi Zero 2
- Pi Zero "Stub" Camera Cable
- Geekworm Raspberry Pi Hdmi to CSI-2 Module X630

I've got 2 different versions of the enclosure
- pins to slide the pi zero and HDMI module onto
- holes for 2mm screws so you can screw the modules down

I've also created 4 different lids
- Standard lid
- Lid with space for you to use the header pins
- Lid with space for the .91" oled display
- Lid with space for a .91" oled display unit ( fitted to a board )

I need to figure out a bet