PI-KVM ZeroW Case

This is a case for a Pi-KVM based on a Raspberry Pi ZeroW with HDMI to CSI-2 bridge.

Project Website: https://pikvm.org/
Project GitHub: https://github.com/pikvm/pikvm

The mounting points on the lid are made for the following HDMI to CSI-2 bridge: https://www.aliexpress.com/item/4000102166176.html (Color: Black)

To mount the electronics you need:
8x M2x6 screws
8x printed spacers

Use the printed spacers to avoid the screws to touch the electronics. To close the lid begin to snap it in on the HDMI connector side. If the lid does not close well, check if there are tiny blobs on the top layer that prevent the lid to snap in properly.

_15.03.2021_ - Added a 15mm higher case to use RPi with heatsinks.
_25.03.2021_ - Reworked the case and lid: thicker Walls, RPi slightly repositioned to access the sdcard and added a hole for HDMI out.
_02.04.2021_ - Board standoffs improved