Thingiverse
Pi Plate Remix
von noisedoctor
84
Downloads
69
Likes
1
Makes
I wanted to celebrate "pi day" with the pie plate by DaveMakesStuff. My slicer didn't like the bottom of the plate, so I did a hack remix to make the bottom flat against the plate.
I was able to print without supports, though the undersides of the plate edge weren't the best. I wasn't going for perfection. You may prefer to print with supports depending on how well your printer bridges.
Fokoos Odin-5 F3
.4mm nozzle
PrusaSlicer 2.4
.45mm line width
~SDG
I was able to print without supports, though the undersides of the plate edge weren't the best. I wasn't going for perfection. You may prefer to print with supports depending on how well your printer bridges.
Fokoos Odin-5 F3
.4mm nozzle
PrusaSlicer 2.4
.45mm line width
~SDG
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!