Thingiverse
Pi tray
von jinx
4
Downloads
5
Likes
0
Makes
After running out of desk space I made this tray/shelve to home my PI..
its a little wasteful on supports! but will require supports "touching build surface" in cura.
ideally it meant to be printed at .3 layer height, you require for brass standoff to complete.
there two 5 mm holes for screws or just epoxy.
its a little wasteful on supports! but will require supports "touching build surface" in cura.
ideally it meant to be printed at .3 layer height, you require for brass standoff to complete.
there two 5 mm holes for screws or just epoxy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!