Slicer Discord
Pi Zero 2w Skadis Mount – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Pi Zero 2w Skadis Mount

56 Downloads
22 Likes
42 Makes
Zum Modell
Its all one piece, I used supports on the little standoffs. But you could probably print it without them, I just didn't like the quality from it. I used some what I believe to be M2 screws but I bet you can change the hole diameter size. Then i just screwed the pi down straight into the plastic.
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
Print-in-place-Design
Print-in-place Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen