Thingiverse
Pi Zero and MMDVM HS Hat Case
door alistairuk
12
Downloads
5
Likes
0
Makes
This is a simple Pi zero case with room for an MMDVM HS amateur radio hotspot hat.
Intended to be laser cut from transparent acrylic so any screen can bee seen. Designed to be screwed together with buts on the top, but tolerances are tight and friction is sometimes enough to hold the screws in place is M3 screws are used.
Some power connecters are a little tight but most will fit. The other connecters, other then the antenna, are not intended to be used.
Intended to be laser cut from transparent acrylic so any screen can bee seen. Designed to be screwed together with buts on the top, but tolerances are tight and friction is sometimes enough to hold the screws in place is M3 screws are used.
Some power connecters are a little tight but most will fit. The other connecters, other then the antenna, are not intended to be used.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!